Enter keyword search:As HJ-005
  • | Contact Us
  • AddNo 9 shanghuang road,road,Lanxi Economic Development District,Jinhua City,Zhejiang Prv.china
  • Tel0086-579-88766519/88766236
  • M.T.18006891269
  • Fax0086-579-88762388
  • E-mailkevin@royaltools.com.cn
  • Web
LocationNews > Text
Garden tools and maintenance knowledge
News > Text
1. Four-stroke gasoline engine fuel as a clean fuel (over 90), four-stroke engine oil lubricants for the SAE30. New machine running idle 2 hours, heat oil changes before normal use. Normal use 30 hours or so total replacement of an oil. Before and after each use check the oil level.
2. Continuous air-cooled four-stroke gasoline engine work, crankcase temperature can not exceed 90 degrees, overheating shut down after 15-20 minutes to work. Fuel filler must be carried out in the cold state machine. Cold confidential at low speed 3 minutes before normal use, no long grass, do not use the maximum throttle.
3. Gasoline Do not overdrive. Except for emergency situations, should be shut down in the low state.
4. Oil to be correct, genuine, clean gasoline to clean, fresh.
5. Non-professionals shall not adjust the carburetor. Must be adjusted, generally the oil needle gently tighten clockwise, then counter-clockwise twist from 1.5 to 1.75 weeks.
6. Always check the air cleaner filter, wash with soap and water or periodic replacement.
7. Gasoline run 100-300 hours after application of wood or bamboo remove coke once. Remove the cylinder head cleared, remove the cylinder, cylinder head, piston, valve, etc. attached to the carbon deposition. Carbon into the cylinder bore and the valve may not seat.
8. Particular cylinder gasoline engine to keep the heat sink clean.
9. Refueling, inspection, repair, maintenance, to disconnect the spark plug cap, not to smoke, away from open flame.
10. Do not operate indoors. In addition to the operator when the machine work, the related personnel leave the machine 15 meters.
11. Inspection before and after each use machine parts and other parts of the bolt tightness.
12. A clutch, the machine is not exposed in the clutch installed and before the start gasoline engine.
13. Other lubricating machine parts, according to the need to follow the instructions to add oil or grease on a regular basis.
Copyright | Zhejiang Royal Garden Tools Manufacture.,Co.,Ltd.   Support:Easthardware ICP11031537-1